22
Supplemental Page B: Setting a Height Limit
Please follow this procedure if you would like to limit the distance that your TV Lift extends.
To set your Travel Limit with IR Controls:
If you want the lift system to always go to its full extension, do NOT use the Height Limit Insert. Simply leave it unplugged and
the system will always travel to the full extension. To limit the travel, follow the procedure below:
1. Using the IR Receiver, run the lift system to
the ideal height limit position and stop it there.
2. With the lift system stopped, plug the Height
Limit Insert into the available RJ45 port on the
Control Box. This will set the height limit at this
position for both the IR Remote (or 3
rd
party
universal remote) and the IR Receiver.
3. If the height limit is set at the incorrect
position, remove the Height Limit insert and
repeat the procedure.
To set your Travel Limit with RF Controls:
If you want the lift system to always go to its full extension, do NOT use the Height Limit Insert. Simply leave it unplugged and
the system will always travel to the full extension. To limit the travel, follow the procedure below:
1. Using the Wired Backup Switch, run the lift
system to the ideal height limit position and stop
it there.
2. With the lift system stopped, plug the Height
Limit Insert into the available RJ45 port on the RF
Receiver. This will set the height limit at this
position for both the RF Remote and Backup
Switch.
3. If the height limit is set at the incorrect
osition, remove the Height Limit insert and
repeat the procedure.
