25
wind angle will be compensated for the roll and thus increasing the
accuracy.
The roll sensor is not available at the time for this manual.
5.3.9 C69 Pitch adjustment
This adjustment is valid only if roll is selected in C73 (you have to exit
and enter the calibration again after C73 is set to Roll).
Adjustment of the pitch offset. Mount the pitch transducer according to
the instructions. Adjust the offset so the pitch is displaying 00° when the
boat is horizontal. By entering a minus sign [-] in front of the value the roll
will be decreased by the value. When the offset is without a minus sign, it
will be added.
The pitch sensor is not yet available (at mars 1997).
5.4 C70 Configure Nexus
To return to normal mode, press
KEY
when the text [rET] is displayed.
In the configuration you will be able to tell the Nexus Network where you
have installed the log and wind transducer.
This is important because you may optionally install those transducers at
the Server instead of the instrument.
5.4.1 C71 HDC-master
[On]
= the Compass transducer is connected at the Compass Data
instrument.
[OFF] =
the wind transducer is connected at the Nexus Server.
5.4.2 C72 Log-master
[On]
= the log transducer is connected at the Compass Data instrument.
[OFF] =
the log transducer is connected at the Nexus Server.
5.4.3 C73 Function on terminal In3
Select function on the terminal pin 3. The following functions are
available:
If other function then water temperature is selected, you may still use the
water temperature function by connecting the NEXUS log transducer at
the Server or at the Wind Data instrument.
[TMP]
Standard temperature function for the log transducer.
[TRM]
Use the external trim button for the SPEED Trim
function.
[STR]
Use the external trim button for the STEER
Pilot function.
[MOB]
Use the external trim button for the M.O.B. function.
[Roll]
Use the roll sensor to compensate wind speed and angle.
CALIBRATION
