6
7
Programming with Code Search
If your product does not respond after you
have tried all the codes for your brand, or if
your brand is not listed, try searching for your
code by following these steps.
1. Manually turn on the device (TV, VCR,
etc.) to be controlled.
2. Press and hold the
P
(Program) button until
the red indicator stays on. Release the
P
button.
3. Press and release the desired mode button
(TV, VCR, etc.). The red indicator blinks,
then stays lit.
4. Press the Channel Up button repeatedly (up
to 300 times) until the device to be con-
trolled changes channels.
If you accidentally overshoot the desired
code, press the Channel Down button to
backtrack through the library until the
device changes channels. Pressing Channel
Up changes the direction to forward again.
5. Press and release the Enter button to set the
code.
If the device does not have a Channel Up
button, use Play (VCR/DVD) or Power in-
stead. If you go all the way through the code
library without finding the correct code the
indicator blinks a few times then goes off.
The Code Search method above assumes that
you want to store VCR or DVD codes under
the VCR/DVD button, SAT or Cable codes
under SAT/CBL, etc. If you want to store a
SAT code under VCR/DVD, first press the
P
(Program) button. Then press VCR/DVD.
Then enter any SAT code from the code list.
Then proceed from step 4 for Code Search
above.
Code Programming
The
P
(Program) button is used to program the
remote. You can program the remote using the
code for your brand of device from the code
list, or search through the library of codes until
you find a code that works for your device.
You can store any kind of code under any
mode (except TV). For example, you can store
a CD code under the SAT/CBL button, or an
Audio code under the DVD/VCR button, etc.
However, you can only store TV codes under
the TV button.
Direct Code Entry
1. Press and hold the
P
(Program) button until
the red indicator stays on. Release the
P
button.
2. Press and release the desired mode button
(TV, VCR, etc.). The red indicator blinks,
then stays lit.
3. Enter the 3 digit code from the code list.
Note: The red indicator turns off after a
valid code entry and flashes for an invalid
code.
4. With your device on, press Channel Up. If
the device responds, no further setup is
required.
Note: If some buttons on your device do not
operate, try one of the other codes for your
brand.
Code Programming, cont.
