10.
Specifications
PROGRAMMABLE AC/DC POWER SOURCE
236
Specifications are valid under the following settings and conditions and after a warm-up period of
30 minutes at least, unless otherwise noted.
Load
Resistance load of power factor 1
Signal source
INT (internal signal source)
Output voltage waveform
Sine wave
Remote sensing
Off
AGC/Autocal Off
Current Limiter
Factory default setting
Output terminal
Output terminal block on the rear panel
[set] indicates a setting value, and [rdg] indicates a read value.
The description noted with "/" indicates that the specification changes by the output range, such as
"100 V range specification/200 V range specification."
A value with the accuracy is the guaranteed value of the specification. However, an accuracy noted
as reference value shows the supplemental data for reference when the product is used, and is not
under the guarantee. A value without the accuracy is the nominal value or representative value
(shown as typ.).
KP3000S corresponds to Clause 2 (8) Frequency converter, Appendix 1 of Export Trade Control
Ordinance. The permission for exportation of the Japanese Administration is necessary for export
outside Japan.
10.1 Output
Function
KP3000S
Output Function Continuous, Sequence, Simulation
10.2 Output
Range
KP3000S
Output Range
100 V range, 200 V range
Summary of Contents for KP3000S
