4.2 Sweep
4-22
WF1945B
Sweep (Mode: Continuous) (
MODE
→
SWEEP
→
MODE : CONT)
In a Sweep (Mode: Continuous), oscillation occurs by varying parameters such as the frequency and
amplitude continuously between the start and stop settings.
Operation is described for producing a waveform output with linear and continuously frequency.
The waveform is a sinewave with arbitrary Amplitude and DC offset.
Start amplitude: 1Vp-p
Stop amplitude: 2Vp-p
Sweep time: 2 seconds
Operation:
(1) Set sweep MODE to continuous (CONT)
①
Press the
MODE
key, then the
SWEEP
key.
②
Use the
and
keys to produce the following display (MODE flashes).
SINGLE
CONT GATED
F-SWP:
TYPE
SOURCE
MODE
4
③
Press the
ENTER
key, then use the
and
keys to produce the following display
(CONT
flashes).
SINGLE
CONT
GATED
F-SWP:
TYPE
MODE
FUNCTION START
4
④
This completes setting the sweep mode to continuous. Press the
EXIT
key once to release the
setting
mode.
Summary of Contents for WF1945B
