Hunan Next Generation Instrumental T&C Tech. Co., Ltd.
NGI
l
NGI
N3410 Series
Triple-channel Programmable DC Power Supply
21
4.3.6 Timer
After the timer function is turned on, at this time users start output of the power
supply, the countdown starts on the interface. When the time is up, the power
supply shuts off the output. The time accuracy is 1s. In the power output state, the
countdown is still workable with timer function turned off. Every time a channel
output is turned on, the countdown will start again.
Figure 20 Timer Setting
Steps to set parameters under
Timer
:
1. Press
＞
to find more functions.
2. Press button below
Timer
on the screen to enter timer interface.
3. Press button below
Second
on the screen.
4. Press
or
Enter
on time setting area.
5. Input digit by pressing numeric buttons or pressing
to move the cursor
and rotate
to adjust the value.
6. Press
or
Enter
to confirm the setting.
7. Press button below
Timer
.
8. Press
or
Enter
on Timer setting area.
Note: Output Pos is for output wiring position. The options are front and rear.
