Complete the following steps to install a C Series I/O module in the chassis.
1. Make sure that no I/O-side power is connected to the I/O module. If the system
is in a nonhazardous location, the chassis power can be on when you install
I/O modules.
2. Align the I/O module with an I/O module slot in the chassis. The module slots
are labeled 1 to 8, left to right.
Figure 2. Installing an I/O Module in the Chassis
1
2
1. Insertion Groove
2. Latch
3. Squeeze the latches and insert the I/O module into the module slot.
4. Press firmly on the connector side of the I/O module until the latches lock the
I/O module into place.
5. Repeat these steps to install additional I/O modules.
Removing C Series Modules
Complete the following steps to remove a C Series I/O module from the chassis.
ni.com
8
NI-9154 Getting Started
