2-8
|
ni.com
Chapter 2
Installation and Configuration
2.
Connect the AC power source to the PXI Express chassis before installing the module. The
AC power cord grounds the chassis and protects it from electrical damage while you install
the module.
3.
Ensure that the chassis is powered off.
4.
Install a module into a chassis slot by first placing the module card PCB into the front of
the card guides (top and bottom), as shown in Figure 2-5. Slide the module to the rear of
the chassis, making sure that the injector/ejector handle is pushed down as shown in
Figure 2-5.
5.
When you begin to feel resistance, push up on the injector/ejector handle to fully seat the
module into the chassis frame. Secure the module front panel to the chassis using the
module front-panel mounting screws.
Figure 2-5.
Installing PXI, PXI Express, or CompactPCI Peripheral Modules
1
Peripheral Module Front Panel Mounting Screws (2x)
2
NI PXI Express System Controller
3
NI PXIe-1082 Chassis
4
Injector/Ejector Rail
5
Injector/Ejector Handle
6
PXI Peripheral Module
NI PXIe-1082
3
2
4
1
6
5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
