2-6
|
ni.com
Chapter 2
Installation and Configuration
Figure 2-4.
PXI Express System Controller Installed in a NI PXIe-1082DC Chassis
Installing Peripheral Modules
Caution
The NI PXIe-1082DC chassis has been designed to accept a variety of
peripheral module types in different slots. To prevent damage to the chassis, ensure
that the peripheral module is being installed into a slot designed to accept it. Refer to
Chapter 1,
, for a description of the various slot types.
This section contains general installation instructions for installing a peripheral module in a
NI PXIe-1082DC chassis. Refer to your peripheral module user manual for specific instructions
and warnings. To install a module, complete the following steps:
1.
Inspect the slot pins on the chassis backplane for any bending or damage prior to
installation.
2.
Connect the chassis ground screw to the safety ground before installing the module.
3.
Connect the DC power source to the PXI Express chassis before installing the module.
1
NI PXIe-1082DC Chassis
2
NI PXIe System Controller
3
Injector/Ejector Rail
1
2
3
NI PX
Ie-1082DC
