© National Instruments
|
2-7
4.
Ensure that the chassis is powered off.
5.
Install a module into a chassis slot by first placing the module card PCB into the front of
the card guides (top and bottom), as shown in Figure 2-5. Slide the module to the rear of
the chassis, making sure that the injector/ejector handle is pushed down as shown in
Figure 2-5.
6.
When you begin to feel resistance, push up on the injector/ejector handle to fully seat the
module into the chassis frame. Secure the module front panel to the chassis using the
module front-panel mounting screws.
Figure 2-5.
Installing PXI, PXI Express, or CompactPCI Peripheral Modules
1
Peripheral Module Front Panel Mounting Screws (2x)
2
NI PXI Express System Controller
3
NI PXIe-1082DC Chassis
4
Injector/Ejector Rail
5
Injector/Ejector Handle
6
PXI Peripheral Module
3
2
4
1
6
5
NI PXIe-
1082DC
