Safety Compliance Standards
This product is designed to meet the requirements of the following electrical equipment safety standards for measurement, control, and laboratory use:
• IEC 61010-1, EN 61010-1
• UL 61010-1, CSA C22.2 No. 61010-1
Note
For safety certifications, refer to the product label or the
Product Certifications and Declarations
section.
EMC Guidelines
This product was tested and complies with the regulatory requirements and limits for electromagnetic compatibility (EMC) as stated in the product
specifications. These requirements and limits are designed to provide reasonable protection against harmful interference when the product is operated in its
intended operational electromagnetic environment.
This product is intended for use in commercial and light-industrial locations. However, harmful interference may occur in some installations, when the product
is connected to a peripheral device or test object, or if the product is used in residential areas. To minimize interference with radio and television reception and
prevent unacceptable performance degradation, install and use this product in strict accordance with the instructions in the product documentation.
Furthermore, any changes or modifications to the product not expressly approved by NI could void your authority to operate it under your local regulatory
rules.
EMC Notices
Notice
For EMC declarations and certifications, and additional information, refer to the
Product Certifications and Declarations
Notice
Changes or modifications to the product not expressly approved by NI could void your authority to operate the product under your local
regulatory rules.
Notice
The performance of this product can be disrupted if subjected to Electrostatic Discharge (ESD) during operation. To prevent damage,
industry-standard ESD prevention measures must be employed during installation, maintenance, and operation.
Notice
Operate this product only with shielded cables and accessories.
Notice
The length of all I/O cables must be no longer than 3 m (10 ft).
Notice
Do not connect the power input to a DC mains supply or to any supply requiring a connecting cable longer than 30 m (100 ft). A DC mains
supply is a local DC electricity supply network in the infrastructure of a site or building.
EMC Standards
This product meets the requirements of the following EMC standards for electrical equipment for measurement, control, and laboratory use:
• EN 61326-1 (IEC 61326-1): Class A emissions; Basic immunity
• EN 55011 (CISPR 11): Group 1, Class A emissions
• AS/NZS CISPR 11: Group 1, Class A emissions
Note
Group 1 equipment is any industrial, scientific, or medical equipment that does not intentionally generate radio frequency energy for the
treatment of material or inspection/analysis purposes.
Note
In Europe, Australia, and New Zealand (per CISPR 11) Class A equipment is intended for use in non-residential locations.
Environmental Guidelines
Notice
Failure to follow the mounting instructions in the product documentation can cause temperature derating.
Notice
This product is intended for use in indoor applications or mobile applications where only non-conductive pollution occurs or occasional
temporary conductivity caused by condensation is expected.
Notice
All cabling should be strain-relieved near input connectors. Take care not to directionally bias cable connectors within input connectors when
applying strain relief. Refer to the
Data Record System AD User Manual
for information on how to strain relieve cabling.
Notice
Cover all empty slots using filler panels.
2
|
ni.com
|
PXIe-1092DC Safety, Environmental, and Regulatory Information
