NI SHC68-C68-D5 Cable Installation Instructions
2
ni.com
What You Need to Get Started
To use the cable, you need the following items:
❑
NI SHC68-C68-D5 cable
❑
NI 2515 switch module and documentation
Getting Started with the NI SHC68-C68-D5 Cable
Complete the following steps to connect the cable to the switch module and your application. Refer to
Figures 1 and 2 for illustrations of the cable, and refer to Figure 3 for an illustration of the connector.
1.
Connect the cable connector labeled
CONNECTS TO NI 2515
to the
HSDIO
connector on the
NI 2515 module as shown in Figure 1.
Figure 1.
Connecting the Cable to the NI 2515
Note
NI recommends placing your supported NI high-speed DIO device in the chassis slot
immediately to the left of the NI 2515. Use caution when inserting or removing a device immediately
to the left of the NI 2515 when the NI SHC68-C68-D5 cable is connected to the NI 2515, as the cable
connector may overlap slightly into the space of that slot.
2.
Tighten the thumbscrews on the cable.
1
NI 2515
HSDIO
Connector
2
NI SHC68-C68-D5 Connector
3
Thumbscrews
4
CONNECTS TO NI 2515
Label
NI PXI-2515
3
2
1
4
