User Manual
Version 0.10
2.1
Enclosure
Dimensions
436x443x110 mm
Weight
6.95 kg
Color
Dark grey
Table 1:
Enclosure specifications.
NURIA has a metallic enclosure with dimensions 436x443x110 mm that can be flush mounted or at
surface. The cables for the setup can pass through the holes located on the top, where plastic glands
should be used, or through the opening on the back of the cover.
The inside can be accessed by opening the front door using a specific key supplied with the equipment.
The door can be removed and reinstalled quickly, without the need of unscrewing anything, using the
existent pivot hinges, making the setup process easier.
The enclosure was designed to hold two 12V 12Ah lead-acid batteries on its bottom part with maximum
dimensions of 151x98x99 mm.
2.2
Electronics
The electronics of NURIA can be completely separated from the enclosure to simplify the installation or
for maintenance proposes by removing the four screws in the lower part, without the need of splitting all
parts of the panel.
For the panel to work correctly, at least the following hardware should be installed inside the enclosure:
• 150W power supply;
• Two 12V batteries connected in series;
• Touch screen and main boards;
• One loop board.
There are also additional modules that can be acquired separately to provide NURIA with extra capa-
bilities such as:
• Wi-Fi;
• GSM;
• DALI.
2.3
Mounting
Mounting the NURIA directly on the wall should be made using the four screws available on the back of
the enclosure according to figure 1.
2.4
Connections
This section explains how the connections to the panel should be made in order to put it to work. To
make NURIA compatible to the standards
EN54-2/4
, the following instructions should be followed carefully.
2.4.1
Main power supply
There is a three terminal connector with an incorporated fuse of 4A that should be used to connect the
panel to the mains (230VAC) using a cable with 3 wires with cross section of at least 0.5mm
2
.
5
5 / 26
