22
POOL 11
GB
LE
K
LE
K
Electrical connection FIGHTER 1220
1. Install the edge protection on the sharp edges, see
the right image.
2. The supplied relay card (-E34) is installed on the exist-
ing relay card (-E29) using plastic turrets, see image
below.
3. Connect the edge connector wiring between the
supplied relay card (–E34) and relay card (–E29) as
illustrated below.
All electrical connections must be carried
out by an authorised electrician.
Electrical installation and wiring must be
carried out in accordance with the stipula-
tions in force.
Note!
Electrical connection
M5, self-tapping
torx screws
–X6
HAHN
LEK
Relay card, –E34
Relay card, –E29
Edge board wiring
4. Install connection terminals, labels and strain relief
on the panel. Screw the plate into place with two of
the accompanying M5 self-tapping screws, see image
below.
5. Press the 10-pin edge connector with zero number
0111 to 0117 on the relay card –E29 as illustrated to
the right (
Note!
Observe the guide pin in the edge
connector). Then install the loose ends as follows:
- Blue (single) cable with zero number 0111 to
spring terminal –X6:3.
- Brown (single) cable with zero number 0112 to
spring terminal –X6:1.
- Brown (single) cable with zero number 0113 to
spring terminal –X6:2.
- Brown cable with zero number 0114 to 0117 is
installed as follows:
Flat pin sleeve with cable 0114/0115 to
– E34:37.
Flat pin sleeve with cable 0115/0116 to
– E34:39.
Flat pin sleeve with cable 0116/0117 to
– E34:41.
Finally install the loose end of 0117 in the spare
place in the spring terminal –X6:2.
6. Connect the other single cables as follows:
- Yellow/green cable with zero number 0108 to
spare earth connection (-PE) and in spring terminal
–X6:4.
- Brown cable with zero number 0105 to flat pin –
E34:38 and in spring terminal –X6:5.
-E29
Relay card
10-pin
connector
Following cable for Pool 11 used in this kit:
0105, 0108, 0111 to 0117.
A B
I II III
I II
I II
5 0 . 0 C
Va r m v a t t e n t e m
p . 1 .0
LEK
A B
I II III
I II
I II
5 0 . 0 C
Va r m v a t t e n t e m
p . 1 .0
LEK
Electrical
connection
–X6
2 x Edge protection
–E29
–E2
–X1
Summary of Contents for POOL 11
