Nice E Fit L, Instructions And Warnings For Installation And Use

EN

English – 

14

WARNINGS FOR ORDINARY USE

OF THE MECHANISM

7

7.1 - Maximum continuous work cycle

In general, the motors in the “Era” line were designed for residential use and there-

fore for discontinuous use. They guarantee a maximum operating time of 4 minutes 

and in cases of overheating (e.g. caused by continuous prolonged operation) a “ther-

mal protector” for safety intervenes to cut out the power supply, restoring it when the 

temperature returns to normal.

7.2 - Commanding partial opening/closing of the 

awning/shutter (height “H”)

In general, to command the partial opening/closing of the awning (or shutter), press 

the key associated with the partial height during programming (for more information, 

read point 06 of procedure 5.8). If the transmitter has only three keys and only one 

“H” height is memorised, simultaneously press keys 

s

 and 

t

 to recall this height.

What to do if...

(troubleshooting guide)

q

-

responds to the values indicated in the technical characteristics of this manual 

by measuring the electricity between the “common” wire and the electrical phase 

wire supplied with current. Finally, try to supply the opposite electrical phase.

q

When sending a Raise command, the motor does not start

:

This can happen if the awning/shutter is near the Upper limit switch (“0”). In this 

case you must lower the awning/shutter a little bit and give the Raise command 

again.

q

 The system operates in the emergency condition with an operator pre-

sent

:

shock.

– Make sure each part of the motor is still in good condition.

– Perform the deletion procedure (paragraph 5.13) and adjust the limit switches 

again.

CE declaration of conformity

  . . . 

E Fit S (...), E Fit M (...), E Fit L 

(...) 

conform to the essential requisites and other pertinent provisions laid down 

by directives 

1999/5/EC, 2006/95/EC, 2004/108/EC

. The EC declaration of 

conformity can be consulted and printed at www.nice-service.com or request-

  . . .

Mr. 

Luigi Paro 

(Managing Director)

Disposal of the product

-

sonnel at the end of the product’s lifespan.

The product is made of various types of materials: some of them may be recycled, 

while others must be scrapped. Find out about recycling and disposal systems in 

use in your area for this product category. 

 – Some parts of the product 

may contain polluting or hazardous substances which, if released to the environ-

.   

-

cated by the symbol appearing here, the product may not be disposed of 

with other household wastes. Separate the waste into categories for dis-

posal, according to the methods established by current legislation in your 

area, or return the product to the retailer when purchasing a new version. 

disposal of this product.

The product’s packaging materials must be disposed of in full compliance with lo-

cal regulations.

Power supply voltage

: see data on rating plate

Resolution of the encoder

: 2,7°

Continuous operation time

: 4 minutes

Minimum operating temperature

: -20°C

Level of protection

: IP 44

Notes

:

of 20°C (± 5°C).

– Nice reserves the right to apply modifications to products at any time when 

deemed necessary, maintaining the same intended use and functionality.