background image

Page 1 

www.hysecurity.com 

   © 2017 

P/N MX3114  D0584 Rev E

Installation Instructions

 

MX3114

StrongArmPark DC  Articulating Arm

Review the illustrations for the steps involved in assembling the 

articulating arm and attaching it to the StrongArmPark DC chassis.

Tools required

•  Box end wrenches: 7/16 and 9/16 inch 

•  Drill

•  Socket head wrenches: 7/16 and 9/16 inch 

•  Drill bit 9/32 inch

•  1/4 - inch Hex key

For detailed views of the assembly, see page 2.

Breakaway bracket and 

Mounting bracket assembly 

described in 

StrongArmPark DC 

Quick Start Steps

, MX3651-01.

If the tip of the arm droops or angles up too much, level 

the arm by tightening or loosen the linkage fasteners 

that secure the rod ends.

Rod end

Rod end

Arm cap

Tip of the arm

1/4 inch 

fasteners

Drill 9/32 inch 

mounting holes

Connect arm 

light cables. 

Tuck wiring 

inside arm.

Arm light cables inside arm’s 

articulating bracket

Summary of Contents for HySecurity StrongArmPark DC Series

Page 1: ... 7 16 and 9 16 inch Drill bit 9 32 inch 1 4 inch Hex key For detailed views of the assembly see page 2 Breakaway bracket and Mounting bracket assembly described in StrongArmPark DC Quick Start Steps MX3651 01 If the tip of the arm droops or angles up too much level the arm by tightening or loosen the linkage fasteners that secure the rod ends Rod end Rod end Arm cap Tip of the arm 1 4 inch fastene...

Page 2: ...own Technical Support For technical support call your installer or authorized HySecurity distributor Obtain the serial number of your operator before calling For the name of a distributor near you call HySecurity at 800 321 9947 12 1 12 2 12 3 Drill 9 32 inch mounting holes 1 4 inch fasteners provided Arm lights connection Arm lights connection ...

Page 3: ...outside of the chassis to the LED light connector on the arm The wire harness connector is keyed Be sure to seat the connectors before threading close CAUTION To allow full arm travel the cable loop on the outside of the chassis must be a minimum 8 inches 20 cm in length 4 Secure the harness to the chassis with the strain relief bushing DC Power Switch AC Power Switch Remove center plug to feed wi...

Page 4: ...ves battery life COM COM COM COM COM COM COM COM STOP OPEN RADIO CLOSE OPEN OPEN P ARTIAL EYE OPEN EYE CLOSE EXIT LOOP BLOCK EXIT INOBS LOOP OUTOBS LOOP CENTER LOOP EDGE EYE COM 24V EMERG OPEN SHOW LEDs U S ER2 COM NO DC USERRELAY1 Electro mechanical USERRELAY2 Solidstate 24VDC 24VDC 12VDC 12VDC See CAUTION EDGE 24V OPEN COM DUAL GATE COM B A R2 28 FLASH AC RELAY 2 LOGIC OPEN CLOSE STOP MENU RESET...

Reviews:

Related manuals for HySecurity StrongArmPark DC Series