Nice Naked Sliding NKSL400, Instructions And Warnings For Installation And Use

EN

English – 

17

TECHNICAL CHARACTERISTICS OF THE PRODUCT

WARNINGS:

•

All technical specifications stated in this section refer to an ambient temperature of 20°C (± 5°C). • Nice S.p.a. reserves the right to apply modifi

-

cations to products at any time when deemed necessary, maintaining the same intended use and functionality.

Technical characteristics NKSL400

Type

Pinion
Peak thrust 

[corresponding to the ability to 

develope a force capable of moving 

the leaf]
Nominal torque [corresponding to the 

ability to develope a force capable of 

maintaining the movement of the leaf]
Nominal torque speed
Idling speed (the control unit allows 

6 speeds to be programmed, 

approx. equal to: 100, 85, 70, 55, 

45, 30%) 70, 55, 45, 30%)
Maximum frequency of operating 

cycles (nominal torque)
Maximum continuous operating 

time (nominal torque)
Operating limits

Durability

NAKED power supply
Thrust maximum absorbed power  

Insulation class
Emergency power supply
Flashing light output
Open Gate Indicator Output 

 
BLUEBUS output
STOP input 

 
Step-by-step Input
OPEN input 
CLOSE input 
AUX_IN input
Radio connector 
Radio AERIAL Input
Programmable functions
Self-Recognition functions 

 
Operating temperature
Use in acid, saline or potentially 

explosive atmosphere
Protection class
Dimensions and weight 

Electromechanical gearmotor for the automatic movement of sliding gates for residential use, complete with 

electronic control unit
Z: 15; Modulo: 4; Passo: 12,6 mm; Diametro primitivo: 60mm 
12Nm; corrispondente alla capacità di mettere in movimento un’anta con attrito dinamico fino a 400N    

 
6Nm; corrispondente alla capacità di mantenere in movimento un’anta con attrito dinamico fino a 200N    

 
0.18m/s 
0.34m/s 

 
35 cycles / day (the control unit allows up to the maximum described in tables 2 and 3) 

10 minuti  

 
In general, NAKED is suitable for the automation of gates featuring weights or lengths as shown in Tables 1, 2 

 
Estimated between 20.000 cycles and 180.000 cycles, depending on the conditions reported in Table 3

230Vac (+10% -15%) 50/60Hz.
330W 

 
1 (a safety grounding system is required)
With PS124 optional accessory
For 2 LUCYB flashing lights (12V, 21 W lamp)
For 2 x ELDC LED lights or max. 2 x 12V 21W bulbs

One output with a maximum load of 15 BlueBus units

For normally open contacts, for 8,2KΩ; constant resistance, or normally closed contacts; with self-recognition 

(any variation from the memorized status causes the “STOP” command)
For normally open contacts (the closing of the contact causes the “STEP-BY-STEP” command)
For normally open contacts (the closing of the contact causes the “OPEN” command)
For normally open contacts (the closing of the contact causes the “CLOSE” command)
For normally close contacts (the opening of the contact causes the “ALT” command)
“SM” connector for SMXI and SMXIS receivers

52Ω for RG58 or similar type of cable

8 ON-OFF functions and 8 adjustable functions (see tables 7 and 9)
Automatic identification of devices connected with the BlueBus outlet 

Self-recognition of the type of “STOP” device (Normally Open, Normally Closed contact or 8,2KΩ)  

Self-recognition of the gate length and calculation of the deceleration points and the partial opening point.
-20°C ÷ 50°C
No 

IP 44 on the finished product if installed according to proper installation criteria
131x135xh405; 6.5 kg