13
EN
Note 1:
If the transmitter is memorised in “
Mode I
” any key can be
pressed.
If the transmitter is memorised in “
Mode II
” the entire proce-
dure must be repeated for each memorised key to be deleted.
Alternatively this function can be performed using the O-Box
or O-View programming unit.
10
–
ENABLING (or disabling)
THE RECEIVER FOR TRANSMITTER
MEMORISATION
This function enables the user to prevent memorisation of new
transmitters when the procedures “
in the vicinity
” (
factory
setting is
ON
)
or with
“
enable code
” (
factory setting is
ON)
are used as described in this manual.
To enable or disable this
function, proceed as follows:
01.
Disconnect the receiver from the power supply and wait 5
seconds.
02.
Reconnect the power and switch on by pressing the
receiver key until the relative led has completed the sig-
nals indicating the type of code stored in the memory
(see paragraph
5
) and the procedure is activated, indicat-
ed by 2 short
orange
flashes. Then release the key.
03.
(within 5 seconds) Press the receiver key repeatedly to
select one of the following functions (
Warning
!
– on each
press of the key the Led changes colour to indicate the
currently selected function
):
• Led
OFF
=
No lock enabled
• Led
RED =
Memorisation “in the vicinity” locked
• Led
GREEN
=
Memorisation with “enable code” locked
• Led
ORANGE =
Both memorisation modes locked (“in
the vicinity” and with “enable code”).
04.
(within 5 seconds) Press any key of a transmitter already
memorised on the receiver to save the selected function.
Alternatively the lock (or unlock) function can be applied using
the O-Box or O-View programming unit.
www.ApolloGateOpeners.com | (800) 878-7829 | Sales@ApolloGateOpeners.com
