20
EN
Table A
SIGNALS EMITTED BY THE
RECEIVER LED
––
Long
flashes / GREEN
––
On start-up:
1
5
= Code in use: “Flo”
2
5
= Code in use: “O-Code”/“FloR”
3
5
= Code in use: “Smilo”
5
5
= No remote control memorised
During operation:
1
5
= Indicates that the code received is not stored in the
memory
1
5
= During programming, indicates that the code is
already stored in the memory
3
5
= Saving code in memory
5
5
= Memory deleted
6
5
= During programming, indicates that the code is not
authorised for memorisation
8
5
= Memory full
––––––––––––––––––––––––––––––––––––––––––––––––––
––
Short
flashes / GREEN
––
1
5
= “Certificate” not valid for memorisation
2
5
= Code cannot be memorised as is transmitting
“certificate”
3
5
= During programming, indicates that the code has
been re-synchronised
4
5
= Output in “Mode II” not managed on control unit
5
5
= During deletion procedure, indicates that the code
has been deleted
5
5
= “Certificate” with higher priority that the admissible
value
6
5
= Code synchronisation failure
6
5
= Code cannot be memorised due to “incorrect key”
––––––––––––––––––––––––––––––––––––––––––––––––––
––
Long
flashes / RED
––
1
5
= Non-original code block
2
5
= Code with lower priority than the authorised value
––––––––––––––––––––––––––––––––––––––––––––––––––
––
Short
flashes / RED
––
1
5
= “In vicinity” programming mode block
1
5
= Memorisation by means of “certificate” block
2
5
= Memory block (PIN entry)
––––––––––––––––––––––––––––––––––––––––––––––––––
––
Long
flashes / ORANGE
––
1
5
= Indicates that the code is in the memory but
outside the group currently enabled
––––––––––––––––––––––––––––––––––––––––––––––––––
––
Short
flashes / ORANGE
––
2
5
= Indicates activation of block programming
(on start-up)
www.ApolloGateOpeners.com | (800) 878-7829 | Sales@ApolloGateOpeners.com
