Safety devices disabled
: the barrier can be operated even when the safety device on the barrier do not work correctly.
- Activate the barrier command (with the transmitter or key-operated selector switch, etc.); if all is in working order, the pole opens
or closes normally; otherwise the flashing light emits a number of flashes and the manoeuvre is not started (the number of flashes
depends on the reason for which the manoeuvre does not start).
- In this case, the user must press and hold the command within three seconds.
- After approx. 2 seconds the barrier will start to operate in “hold-torun” mode, i.e. the pole will continue to move while the
command is activated; THE POLE STOPS AS SOON AS THE COMMAND IS RELEASED.
If the safety devices are out of service, the automation must be repaired as soon as possible.
Edge light replacement
: to replace the lamp on the control unit it is important to first disconnect X-Bar from any electrical power
sources (including the buffer battery), after which proceed as shown; replace the lamp with a version of the same specifications
(12 V / 10 W - BA15S fitting).
Disposal
: At the end of the automation’s lifetime, ensure that it is disposed by qualified personnel and that the materials are
recycled or scrapped according to current local standards.
Document produced by Nice S.p.a. for installers – All rights reserved
Page ____ of ______
