About this Manual
This user Manual contains instructions which must be followed in order that the product is operated
correctly.
Please ensure that each chamber has fluid in it before switching on the product.
General Notes
Please observe the following safety precautions:
1.
Fill the tank with water prior to connection to power supply.
2.
Connect only to a power supply with the corresponding voltage to that specified on the rating
label positioned on the rear of the unit.
3.
Ensure the power supply has a safety earth (ground) terminal.
4.
Ensure the mains switch and power supply connector are accessible during use.
5.
The mains supply cord fitted to this products is a heat resistant type and should be replaced
by an equivalent type.
6.
Do not block ventilation slots during use and follow installation instructions.
7.
Always follow good laboratory practice by ensuring substances being heated present no risk of
a hazard (explosion, implosion or release of toxic or flammable gases) or that these have been
addressed. When heating substances where liberation of gases occurs suitable extraction
should be used.
8.
Use only liquids specified in this Instruction Manual within their specified temperature range.
If the alarm lamp is illuminated the liquid temperature may be above its recommended
maximum.
9.
Use caution when topping up or draining the tank as the liquid in the tank may be very hot or
cold.
10.
Drain before moving the bath. Allow the liquid to cool to 40°C before draining.
11.
In the event of the over or under temperature alarm being illuminated do not touch the liquid
as it may be very hot or cold.
12.
Recommend using a Lid above 60°C. Take care when lifting the lid - steam and hot vapours
can cause scalding.
13.
Always use the display or a thermometer to check the temperature - do not touch liquid.
14.
If this product is not used in accordance with these instructions, then basic safety protection
afforded by the water bath may be affected.
15.
Before using any cleaning or decontamination method except those recommended, check with
your distributor that the proposed method will not damage the equipment.
Amendments
Issue 1
April
1999
Initial issue instruction book.
Issue 2
September 2001
Revised, NE1 discon layout update
Issue 3
August
2002
Update content
Issue 4
March
2004
Product redesign
Issue 5
October
2005
Note: both tanks filled if only 1 is used.
Issue 6
July
2006
OPT function, turn tank OFF when not in use.
Issue 7
October
2006
Disinfection/sterilisation and temp. terms.
Issue 8
June
2010
2010 model K30.
Symbols
HOT SURFACES
Paragraphs marked by this symbol indicate that a potential hazard to your personal
safety exists from heated surfaces or other appendages on the outside or inside of
the equipment.
CAUTION
This icon accompanies text and/or other international symbols dealing with poten-
tial damage to equipment. When present, it indicates that there is a potential
danger of equipment damage may occur if information stated within the "CAUTION"
paragraph is not adhered to or procedures are executed incorrectly.
The Clifton Range - 3 Year Warranty
3
High Quality Products at Affordable Prices
PROTECTIVE EARTH OR GROUND TERMINAL
Protective earth conductor terminal.
Summary of Contents for Clifton RANGE NE2D Series
Page 13: ...The Clifton Range 3 Year Warranty 13 High Quality Products at Affordable Prices...
Page 14: ...The Clifton Range 3 Year Warranty 14 High Quality Products at Affordable Prices...
Page 17: ...The Clifton Range 3 Year Warranty 17 High Quality Products at Affordable Prices...
Page 18: ...The Clifton Range 3 Year Warranty 18 High Quality Products at Affordable Prices...
