Section 2: Installation
08/2015
13
Rev. 5 50699
Base Assembly
NOTE:
The following descriptions refer to “
Key#
” (#4, etc.) to describe parts. Use the
parts list and Key# in the list to identify all such parts.
1. Place the
Platform Sub Assembly
on the floor upside-down, preferably on 2x4
blocks to raise it up off the floor, if possible.
2. Remove the cotter pins and washers from one side of the Axle Rod (
#19
).
• Axle assembly includes an affixed cotter pin (
#17
), a 5” wheel (
#16
), and then
a flat washer (
#18
).
3. Insert the Axle Rod Assembly through the two axle rod holes, side-to-side.
4. Place one flat washer (
#18
), then a wheel (
#16
) over the other end.
Summary of Contents for BPP1000 Series
Page 5: ......
Page 7: ...08 2015 8 Rev 5 50699...
Page 10: ...Section 1 General Information 08 2015 11 Rev 5 50699...
Page 21: ...08 2015 22 Rev 5 50699...
