Section 2: Installation
08/2015
14
Rev. 5 50699
Base Assembly, Continued
5. Insert a cotter pin (
#17
) through the
Axle Rod.
• Using needle nose pliers, bend
back both haves of the cotter pin
to secure the wheel assembly.
6. Repeat steps two through four (2-4)
for the second axle.
7. Center the axles in the base, and then
insert the four locking screws (
#15
)
into each of the tapped holes in the
bottom of the base.
• Located directly under the axle
holes
8. Tighten the locking screws, and then
secure the Lock Nuts (
#14
).
9. Turn the platform over so it sets on
the wheels.
After inserting the four Cotter Pins, center the
axles, tighten the Locking Screws, and then
secure the Lock Nuts.
Summary of Contents for BPP1000 Series
Page 5: ......
Page 7: ...08 2015 8 Rev 5 50699...
Page 10: ...Section 1 General Information 08 2015 11 Rev 5 50699...
Page 21: ...08 2015 22 Rev 5 50699...
