2
Go-Between Installation and Operation
Transferring Data to PC (Industrial Enclosure)
Data on the Go-Between device is stored in a.txt file. To transfer data to your PC:
1. On the Go-Between, press
Close File
.
2. Disconnect the flash drive from the Go-Between’s USB port.
3. Connect the flash drive to the PC’s USB port.
4. Navigate to the flash drive and open the .txt file to view its contents. It can also be imported into Microsoft
Excel or other spreadsheet software.
POWER
HB
TXD
RXD
FULL
LOST
SA
VED
INSER
T
READ
Y
1
2
3
4
5 6
7 8
9 10
Notes
•
When reset switch is in the
OFF
position and power is connected, only LED #1 will be
ON
.
•
When reset switch is turned from
OFF
to
ON
, all LED’s will be on for several seconds. This is a test mode to
let you know that all LEDs are working.
•
When receiving DATA, #4 and #5 LEDs will light for a short period of time.
•
When #8 LED is on, you can remove the USB drive.
•
If you want to remove the USB drive before #8 LED lights, press the
Close File
button and wait for the #8
LED to be
ON
before removing the USB drive.
Power Source Coming From Indicator
For devices that have the power source coming directly from the indicator use Table 1 and Figure 1.
Table 1. Go-Between Serial Wiring with Power Coming From the Indicator
Serial Output from Source Coming From Indicator
Go-Between Input
TXD
RXD
GND
GND
+5VDC
+5VDC
Figure 1. Wiring When Power Source is Coming From the Indicator
Note
Note the jumper position on the Go Between CPU board.
