Configuration and Calibration
19
4.7.2
Enter Tare Weight
lb
lb
lb
lb
lb
1. Ensure vehicle is empty, then weigh and record TARE (empty vehicle)
weight on an accurate truck scale.
2. In
MENU
screen, select
Calibration
and press
ok
.
3. Select
Tare.
4. Press
ok
(defaults to 10000).
5. Press
edit
.
6. Enter vehicle TARE (empty) weight recorded in Section 4.7.1.
7. Press
.
8.
Press
again to return to
MENU
screen.
Prior to calibration, with the display in the Inclinometer/Net Weight or
Inclinometer mode raise the body clear of the chassis (the factory
recommendation is three or four degrees). Record the bubble
indication setting for use on span calibration and normal weighing.
Note
4.7.3
Set Zero Calibration
lb
lb
1. Make sure the vehicle is on level ground.
Tippers: raise the body clear of the chassis, approximately three or
four degrees.
2. In
CAL
menu, press
to select
Zero
.
3. Press
ok
.
4. Press
cal
.
5. Press
ok
to
Confirm Ch 1 Zero
.
6. Press
to return to
CAL
menu.
Note
The Rice Lake Roll Off and Dump Truck kits are typically LIFT-TO-WEIGH KITS. This means that with the hoist in
the relaxed state (on the chassis), no weight reading is available. The hoist needs to be elevated to a position
showing the correct angle on the in-cab digital display unit, approximately 4 degrees, for the weight reading
degrees to be valid and accurate.
