NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com December 10, 2019 11:29 AM
EML6
LED Emergency Light
INSTALLATION INSTRUCTIONS
Model: EML61UNVWH
What’s In The Box
One (1) EML6
One (1) Mounting Kit
WARNING
- Risk of fire or electric shock. LED installation requires knowledge of luminaires electrical systems. Review the diagrams thoroughly
before beginning. All electrical connections must be in accordance with local codes, ordinances, and the National Electric Code. If
not qualified, do not attempt installation. Contact a qualified licensed electrician.
- Before installation, disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the fuse box.
Using the light switch to turn power off is not sufficient to prevent electrical shock.
- Do not let power supply cords touch hot surfaces.
- Do not mount near gas or electric heaters.
- Use caution when servicing batteries, all servicing should be completed by qualified personnel. Replace every 8 to 10 years
according to ambient. Test regularly in accordance with local codes.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- Do not use this equipment for other than its intended use.
- The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
- Equipment should be mounted in locations and at heights where it will not be subjected to tampering by unauthorized personnel.
- Operating temperature: -15°C - 40°C
- Only use UL Listed, Suitable for Wet Location conduit parts.
- Allow batteries to charge 24 hours before first use.
Tools Needed
A Phillips screwdriver and a drill will be needed to install the
EML6.
Preparation
Carefully unpack the exit light from its packaging. Inspect product for defects due to shipping. Become familiar with
the wiring diagram below before beginning installation. Use a phillips screwdriver to loosen the (2) screws on the
faceplate and remove. Set the faceplate and (2) screws aside. As seen in “Figure 2,” push in the two clips to remove the
the backplate from the fixture, exposing the wires inside.
1
Installing the EML6
Figure 1 -
Wiring Diagram
Figure 2 -
Press in clips to remove fixture
from backplate
Make sure all power is turned off before beginning installation
