NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com July 26, 2021 10:46 AM
ECL3
Slim LED Combo Exit Sign & Emergency Light
INSTALLATION INSTRUCTIONS
Model: ECL310UNVWHG2SD, ECL310UNVWHG2RSD,
ECL310UNVWHR2SD, ECL310UNVWHR2RSD
What’s In The Box
One (1) ECL3
One (1) Mounting Kit
Tools Needed
A Phillips screwdriver will be needed to install the ECL3.
A drill is needed to remove the knockouts if back
mounting.
Make sure all power is turned off before beginning installation
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
•
Review the diagrams thoroughly before beginning.
•
All electrical connections must be in accordance with local codes, ordinances, and the National Electric code.
•
Disconnect power at fuse or circuit breaker before installing or servicing.
•
Do not use outdoors.
•
Do not let power supply cords touch hot surfaces.
•
Do not mount near gas or electric heaters.
•
Equipment should be mounted in location and at heights where it will not readily be subject to tampering by unauthorized personnel.
•
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
•
Do not use this equipment for other than intended use.
•
All servicing should be performed by qualified personnel only.
•
Allow battery to charge for 24 hours before first use.
•
Max mounting height 17ft
SAVE THESE INSTRUCTIONS
Preparation
• Carefully unpack the exit sign from its packaging.
• Inspect product for defects due to shipping.
•
Use screwdriver to carefully remove the front faceplate (See Figure 1)
Mounting and Wiring
Wall Mount (See Figure 2)
•
Use screwdriver to carefully remove the front faceplate.
•
Remove the knock out hole on the center of back plate. Then
remove the oblong knock outs on the back plate that correspond to
junction box holes to be used.
•
Remove the side hole plugs from the housing and snap the lamp
heads onto the unit.
•
Connect the lamp head wiring to the circuit board.
•
Route supply wiring through the center hole and into the housing.
•
Install the fixture on the junction box using the (2) included screws
(#8-32)
•
Connect the wiring per the wiring diagram and push excess wire
into the junction box.
•
Attach the battery connector to the circuit board.
•
Snap out the desired chevron marking(s) from the front faceplate,
reinstall the faceplate and adjust the direction of the lamp heads as
needed.
1
Installing the ECL3
Figure 2 -
Back Mount
Figure 1 -
Faceplate Removal
Flexible Conduit Only
