NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com
NLCSPCW1WH
August 22, 2022 3:14 PM
1
NLC |
Network Lighting Controls
INSTALLATION INSTRUCTIONS
NLCSPCW1WH
What’s In The Box
Tools Needed
A drill and wire cutters will be needed for
installing the NLCSPCW1WH.
One (1) NLCSPCW1WH
NLCSPCMOUNT1
Carefully unpack the unit from its packaging. Inspect product
for defects due to shipping.
1
4
5
2
3
Identify location for installation and cut a 1.60” (41mm) diameter hole for
the NLCSPCMOUNT1.
Materials Needed
Install NLCSPW1WH into the NLCSPCMOUNT1. Secure with the lock nut.
Push up spring-arms on side of the NLCSPCMOUNT1 and slide into the
cut hole.
Ø CUTHOLE
Turn off power to appropriate circuit at the breaker panel.
! IMPORTANT SAFEGUARDS !
WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
1. Do not use outdoors.
2. Do not use this equipment for other than its intended use.
3. The installation should be performed by a licensed electrician.
4. To prevent death, injury or damage to property, this product must be installed in accordance to National Electrical Code (NFPA70) in the US or
Canadian Electrical Code (CSA 22.1) in Canada.
5. Disconnect power before installing the product or servicing it.
6. Wait until fixture has cooled down before installing or servicing the fixture.
SAVE THESE INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
What’s In The Box
