4
FOR SAFE INSTALLATION: During Checking and Adjustment
1.4
During Checking and Adjustment
WARNING
• Never touch the wheel while it is rotating.
Injury may result.
• Never open the processing chamber cover during lens processing.
Spray containing processing waste may cause eye damage.
• Be sure to visually check that the wheels are not chipped or cracked before processing.
If chipped or cracked wheels are used, they may break or shatter resulting in injury.
• Do not inhale vapor on particles produced during lens processing. Wear a mask, glasses, and other
such protective gear.
Vapor or particles may be toxic depending on the materials.
CAUTION
• In the event of smoke or strange odors, immediately turn off the instrument and disconnect the
power plug from the wall outlet.
Use of the instrument under such abnormal conditions may cause fire or electric shock. In case of fire,
use a dry chemical (ABC) extinguisher to extinguish the fire.
• Immediately replace the power cord if its internal wires are exposed, power is intermittent when the
cord is moved, or the cord and/or plug are hot to the touch.
Electric shock or fire may occur.
• In the event of malfunction, disconnect the power cord from the wall outlet. Never touch the interior
of the instrument.
Electric shock or fire may occur.
• Be careful not to injure hands on any sharp edges when removing a processed lens.
The lens edge may cause finger injury.
• Safety bevel the front and rear surfaces of glass lenses after processing.
Subtle burrs may cause skin damage.
• Be careful not to get fingers caught when chucking (securing) a lens.
Injury may result.
• Protect the display from splashing water. Also, never operate the display with wet hands.
Water seeping into the instrument may result in electric shock, malfunction, or fire.
• Always clean up any spilled water from the pump tank with a clean dry cloth.
A slippery wet floor may cause injury.
