3 - 10
Frame curve (F CRV)
Indicates the frame curve value measured
by the tracing unit.
Bevel tip point (PNT)
Indicates the amount that the bevel is
moved, either backward or forward.
In the guided processing mode, align the
cursor to
PNT
. Change the value with
or
to move the bevel forward
or backward parallel to itself.
[
←
15.0 -
→
15.0 mm (increment: 0.1
mm)]
Bevel curve (B CRV)
Indicates the bevel curve value.
In the guided processing mode, align the
cursor to
B CRV
, and change the value
with
or
. The “A” mark on the
head of the value means that it is calcu-
lated by computer and is the optimum
value.
Bevel sectional view
Represents the bevel section where the
Sectional view position line is on the traced
outline.
The mark “
” over the scale represents
the bevel tip point.
One graduation of the scale is equal to
0.2 mm.
Sectional view position line
Represents the position of the indicated
bevel section along the traced outline.
Bevel tilting amount (TILT)
Indicates the amount by which the bevel
tip point is shifted forward or backward.
Adjust the bevel tip point diagonally-
opposite to the boxing center of the tilt
base position.
The value can be changed in 0.1 mm
increments.
Tilt base position
This is the base bevel position for deter-
mining the tilting amount.
Groove width (WID)
Indicates the groove width for nylor
frames.
[0.6 - 1.2 mm (increment: 0.1 mm)]
Groove depth (DEP)
Indicates the groove depth for nylor
frames.
[0.0 - 0.8 mm (increment: 0.1 mm)]
Groove dip point (PNT)
Indicates the amount that the groove for
nylor frames is moved, either backward or
forward.
In the guided grooving mode, align the
cursor to
PNT
.. Change the value with
or
to move the groove forward
or backward parallel to itself.
[
←
15.0 -
→
15.0 mm (increment: 0.1
mm)]
Groove curve (G CRV)
Indicates the groove curve value for nylor
frames.
In the guided grooving mode, align the
cursor to
CRV
, and change the value
with
or
. The “A” mark on the
head of the value means that it is calcu-
lated by computer and is the optimum
value.
Groove sectional view
Represents the groove section where the
Sectional view position line is on the
traced outline.
The mark “
” over the scale represents
the groove dip point.
One graduation of the scale is equal to
0.2 mm.
* - apply to the LE-9000EX Express
only.
Summary of Contents for LE-9000DX Express
Page 1: ...NIDEK PATTERNLESS EDGER LE 9000EX Express LE 9000DX Express OPERATOR SMANUAL...
Page 17: ...2 9 or or Top view...
Page 19: ...2 11...
Page 153: ......
