4 - 28
5. Simulate the bevel section at each point of the outline on the screen.
:
The sectional view position line rotates clockwise.
:
The sectional view position line rotates counterclockwise.
To stop the line movement, press
or
again.
: The sectional view position line jumps to the point that the lens edge is thinnest (
J
) and
thickest (
J
) alternately.
If the bevel position needs to be changed;
Follow the procedures from Step 6 - of “4.5.1.2 Guided processing mode” (p. 4-21) to change
the bevel tip point (PNT).
NOTE
• As for the curve value, do not change it but leave it as the rear base curve (REAR).
The specified curve, front base curve or Ratio is not appropriate for an EX lens to
process the bevel properly.
6. Start processing.
Press
.
Rough processing
↓
Finishing
↓
Polishing (Only when
is selected with Type PLB or PLB-2R.)
↓
Chamfering (Only when
is selected.)(LE-9000EX Express only)
↓
Processings are complete. [The Layout screen returns.]
7. Remove the lens.
WARNING
• Open the soundproof cover after making sure that the wheels have stopped completely.
• Release the chuck by pressing
after making sure that the wheels have stopped
completely.
When the chuck is released before the wheels have stopped completely, if a lens is
dropped, it may contact the turning wheels and its scattering may cause an injury.
Summary of Contents for LE-9000DX Express
Page 1: ...NIDEK PATTERNLESS EDGER LE 9000EX Express LE 9000DX Express OPERATOR SMANUAL...
Page 17: ...2 9 or or Top view...
Page 19: ...2 11...
Page 153: ......
