8 - 2
3. Open the soundproof cover.
4. Start dressing.
CAUTION
• Apply the end surface of the dressing stick to the wheel, not the corner or the edge.
Otherwise, the wheel may be damaged.
• Hold the dressing stick with both hands.
If the stick is held with one hand, the stick cannot be held strongly enough, the corner
of the stick may collide with the wheel and damage it.
• Hold the dressing stick so that its end is 2 - 3 cm away from your fingers.
If the stick is held closer than this distance, you may contact the wheels and fingers
may get hurt.
• Be sure to replace the dressing stick worn some 4 cm with the new one. Especially,
replace the dressing stick for the polishing wheel when it becomes shorter than 5 cm.
It is hard to hold a shortened dressing stick, and your fingers may get hurt or the
wheels may be damaged.
[Dressing the roughing wheel for glass lenses and the finishing wheel]
1) Press
.
Water will run for a few seconds and the wheels will begin to turn at the same time.
2) Wet the dressing stick well with running water.
3) Press
to stop the water.
4) Apply the dressing stick a little forcefully to
the turning wheel.
Keep applying it for about five seconds.
5) Press
.
Water will run to clean the wheel.
6) Repeat Steps 2) - 5) a few times.
7) Press
.
Water will stop running and the wheels will stop turning.
Summary of Contents for LE-9000LX
Page 1: ...PATTERNLESS EDGER Model LE 9000LX OPERATOR SMANUAL ...
Page 17: ...2 9 Top view or or ...
Page 19: ...2 11 ...
Page 145: ......
