3 - 12
Frame curve (F CRV)
Indicates the frame curve value measured
by the tracing unit.
Bevel tip point (PNT)
Indicates the amount by which the bevel
is moved, either backward or forward.
In the guided edging mode, align the
cursor to
PPNT
.. Change the value with
or
to move the bevel forward
or backward parallel to itself.
[
←
15.0 -
→
15.0 mm (step: 0.1 mm)]
Bevel curve (B CRV)
Indicates the bevel curve value.
In the guided edging mode, align the
cursor to
BB CRV
, and change the value
with
or
. The “A” mark on the
head of the value means that it is cal-
culated by computer and is the optimum
value.
Bevel sectional view
Represents the bevel section where Sec-
tional view position line is on the traced
outline.
The mark “
” over the scale represents
the bevel tip point.
One graduation of the scale is equal to
0.2 mm.
Sectional view position line
Represents the position of the indicated
bevel section along the traced outline.
Bevel tilting amount (TILT)
Indicates the amount by which the bevel
tip point is shifted forward or backward.
Adjust the bevel tip point at the diago-
nally-opposite to the boxing center the
tilt base position.
The value can be changed in 0.1 mm
increments.
Tilt base position
This is the base bevel position for deter-
mining a tilting amount.
Summary of Contents for LE-9000LX
Page 1: ...PATTERNLESS EDGER Model LE 9000LX OPERATOR SMANUAL ...
Page 17: ...2 9 Top view or or ...
Page 19: ...2 11 ...
Page 145: ......
