4 - 5
NOTE
• If there is 1 mm or more of difference in circumference between right and left rims, the tracing
error occurs (Retracing starts automatically and the LEDs beside
and
blink for a
few seconds) and pressing
does not read the traced data. In such a case, perform the
single rim tracing.
4.3.1.2 Tracing single rims
This is a procedure to trace one of the frame rims.
1. Set frames into the tracing unit.
See Step 1 of “4.3.1.1 Tracing both rims” (p. 4-4).
2. Press either
or
.
For tracing the rim for left eye
Press
.
For tracing the rim for right eye
Press
.
NOTE
• FPD (Frame Pupillary Distance) cannot be measured when a single rim is traced.
Measure it manually and input the data on the Layout display.
4.3.1.3 Semiauto tracing
This is a procedure to bring the stylus into the bevel groove of the frame with fingers when the
stylus cannot be set in the groove automatically.
1. Set frames into the tracing unit.
See Step 1 of “4.3.1.1 Tracing both rims” (p. 4-4).
2. Hold
*1
down for three seconds.
The stylus will move and stop at the tracing start position.
3. Use fingers to set the stylus into the groove.
*1 To trace a single rim, hold
or
down for 3 seconds.
Summary of Contents for LE-9000LX
Page 1: ...PATTERNLESS EDGER Model LE 9000LX OPERATOR SMANUAL ...
Page 17: ...2 9 Top view or or ...
Page 19: ...2 11 ...
Page 145: ......
