4 - 42
9. Remove the lens with the lens cup from the pattern setting unit.
10. Edge the lens.
Processing will not start if it is judged that the lens size is not enough for processing in the lens
shape measurement*
12
.
11. Press
to switch the side (R or L), and edge the lens of the other side in the same
manner as Steps 4 - 10.
12. After both lenses are processed, press
to exit from the FC mode.
[Simple frame changing mode]
When the lens size is large enough for the new frame, there is no need of lens tracing. Skip Steps
5, 6, 8 and 9 so that trouble for lens tracing can be saved. The ICE-9000 blocks a lens whose
frame is to be changed with a lens cup at the rim center. Pressing
in the FC mode establishes
the simple frame changing mode automatically. This is because the ICE-9000 has already checked
that the lens size is sufficient and outlines do not need to be overlaid by the LE-9000.
*12 In the frame changing mode or simple frame changing mode, a lens can be measured though it
has no extra margin because lens shape will be measured, before processing, at 1.5 mm inside
of the traced outline with the feeler.
Summary of Contents for LE-9000LX
Page 1: ...PATTERNLESS EDGER Model LE 9000LX OPERATOR SMANUAL ...
Page 17: ...2 9 Top view or or ...
Page 19: ...2 11 ...
Page 145: ......
