5 - 5
14) Data Transfer
: NON, VALUE, MATER, POLIS, BF, ALL
Factory setting: NON
Selects the kinds of data that the edger does not accept when receiving the data from an
external device. The selected data in the parameter will be transmitted, but not accepted by
the edger. On the edger side, the previous data remains active even after the data transmission.
Only when the communication specifications is special and the “Ext. interface” parameter is set
to “DVI”, this setting is available.
NON:
No received data will be disabled; All the data will be recognized and shown
on the display.
VALUE: All the data of lens layout are disabled.
MATER: The data of lens material is disabled.
POLIS:
Only the data of “POL (Polishing)” is disabled.
BF:
Only the data of “BIF (bifocal) mode” is disabled.
ALL:
All the data of lens layout and processing conditions are disabled.
15) BF ChuckLayout Side
: ±
FF
mm
(If a minus value is input, the lens will be processed with its blocked point at the specfied
value
outside from the top line center of segment.)
Factory setting: –5 [mm]
16) BF ChuckLayout Height
: ±
FF
mm
Factory setting: +5 [mm]
Sets the lens layout for blocking the bifocal lens. Specify the shifted values from the top line center
of the segment in blocking the bifocal lens. When using the NIDEK Centering device, Model
CE-1, leave the setting at the factory setting (5 mm outside, 5 mm up) and never change it.
17) TILT Function
: None, Exec
Factory setting: None
Selects whether or not to use the tilting function in guided edging mode. If a lens has an
extreme difference in width between the edge thickest point and thinnest point, the appearance
of the mounted lenses will get better by tilting the bevel.
18) Reverse PC Grind
: None, Exec
Factory setting: None
Selects whether or not to use the roughing function while changing the lens rotation direction to
improve the axis accuracy of polycaronate lenses. To process a lens with greater accuracy,
select “Exec”. When “Exec” is selected, however, the processing waste may become bigger
or the lens edge may become rough after processing.
19) Reverse GLS Grind
: None, Exec
Factory setting: None
Selects whether or not to use the roughing function which changes the lens rotation direction to
reduce the processing time of a glass lens. To put a premium on the processing time reduction, set
this parameter to “Exec”. Setting this parameter to “Exec” roughly edges a lens by automatically
changing the position to be contacted with the wheel from side to side so that the roughing wheel
will not be worn on one side.
Summary of Contents for LE-9000LX
Page 1: ...PATTERNLESS EDGER Model LE 9000LX OPERATOR SMANUAL ...
Page 17: ...2 9 Top view or or ...
Page 19: ...2 11 ...
Page 145: ......
