5 - 7
5.3 Storing Initial Display
This function stores the following items on the Layout display as the initial display which appears just
after power-up.
If the factory-set items on the initial display do not satisfy the operator’s need, it is possible to
change the items to be displayed and restore them. This function eliminates the inconvenience
of changing the unnecessary items every time the initial layout display appears.
<Items to be stored>
The items with is changeable and can be stored.
• FPD, DBL, or Eye point layout (whether or not to select the eye point layout]
• PD or 1/2PD [inputting form of pupillary distance]
• , PD , or BT (inputting form of height of the optical center)
• ACT, BF, or PAS [Layout mode]
• PLA, HPL, PC, GLS, ACR, or TRX [Lens material] (Except for glass lenses of Type PLB)
• MTL, CEL (ZYL), PNT, or NYL [Frame material]
• AUT, GUI, EX, or Blank [Grinding mode]
• POL or (Blank) [Whether or not to perform polishing]
(only for Type PL4, PLB, and PLB-2R)
• R or L [The side which appears first after
is pressed.]
Each value on the display cannot be stored. For setting the respective preset values for
FPD, PD, and height of the optical center, see “5.2 Parameter Settings” (p. 5-2).
<Storing method>
1. Change the settings.
Set the settings of the above items on the Layout display as desired.
2. Store the new settings.
Hold
down for 5 seconds.
A beep will be produced to indicate that items on the display have been stored.
㧚ޓ
㧚ޓ
ޓ㧚
㧚ޓ
㧹㧵㧺ޓޓ㧢㧡
㧲㧼㧰㧦㧢㧥㧜㧜ޓޓޓޓޓޓޓޓ
㧼㧰
ޓ㧦㧢㧞㧜㧜ޓޓޓޓޓޓޓޓ
ޓޓޓ㧦ޓޓ㧞㧜ޓޓޓޓޓޓޓޓ
㧿㧵㨆㧦ޓ㧜㧞㧜ޓޓޓޓޓޓޓޓ
㧭㧯㨀ޓޓޓޓޓޓޓޓޓޓޓޓޓ
㧹㧱㧹㧦ޓ㧝㧜㧜ޓޓޓޓޓޓޓޓ
㧼㧸㧭㧹㨀㧸㧭㨁㨀ޓޓޓޓޓ㧾
Summary of Contents for LE-9000LX
Page 1: ...PATTERNLESS EDGER Model LE 9000LX OPERATOR SMANUAL ...
Page 17: ...2 9 Top view or or ...
Page 19: ...2 11 ...
Page 145: ......
