a. Set the rotary switch at AC A.
b. In AC current measurement, ZERO is not needed. Do not press DC A ZERO button.
c. Press the trigger to open the jaw and fully enclose the conductor to be measured. No air gap is allowed between the
two half jaws.
d. The clamp meter will automatically select proper range. If users want to select range, press the range button before
pressing the DC A ZERO button.
e. Read the measured value from the LCD display.
Summary of Contents for NI349PR
Page 1: ...AC DC POWER CLAMP MULTIMETER NI349PR Manual...
Page 7: ...Figure 1...
Page 18: ...3 2 AC Current Measurement...
Page 20: ...3 3 DC Current Measurement...