PROGRAMMING
7
Nieco Corporation - ExVection Toaster 6220
PROGRAMMING
Use the
buttons to change settings.
To program the time and heat, hold down the button you
wish to program for 3 seconds.
Push the button again to change the bottom heat.
Push the button again to change the speed.
Push and hold the button for 3 seconds to save changes.
4
20
20
The display will show
This is the top heat setting, 0 is off and 20 is the
maximum setting. For most products, set to 20.
4
The display will show
0
0
This is the bottom heat setting, 0 is off and 20 is the
maximum setting. For most products, set to 20.
Some toasters are top heat only, and do not have
bottom heaters.
4
13
13
The display will show
This is the time, in seconds, that it takes to toast.
4
>++<
>++<
The display will show
This means the changes have been saved.
CLEANING AND MAINTENENCE
2
3
4
5
Tools
Instructions
1.
Wait for toaster to cool
.
2.
Remove the front guard.
3.
Lift belt and brush the area between the belt.
4.
Remove the crumb pan.
5.
Wipe the cavity of the toaster.
Note: The speed can be
changed temporarily by
using the up or down
arrows but will default
to programmed settings
when a preset button is
pressed. Permanent
speed changes must be
done in programming
mode.
