SD64 Series
Operating & Safety Instructions
USA – 04/16
Issue 04
24
4.3
GROUND CONTROL OPERATION
ALWAYS ALLOW THE ENGINE TO WARM UP BEFORE OPERATION.
4.3.1
GROUND CONTROL INSTRUCTIONS
ALL MODELS
1)
Check below, above and around the basket for any obstructions or hazards before operating any
function.
2)
Ensure all red emergency stops are out.
3)
Turn
Base/Basket
selector at ground control station to
Ground
(Clockwise).
DIESEL ENGINE
4)
For a cold engine start go to step 5) or for a warm engine start go to step 6).
5)
COLD ENGINE
: - turn the
Diesel Glow/Start
selector to the
Glow
position (anti-clockwise). This
engages the glow plug pre-heat system. Hold for 3-5 seconds then turn the key to the
Start
position (fully clockwise) and the engine will fire. If the engine doesn’t fire, then repeat this step
6)
WARM ENGINE:
- turn the
Diesel Glow/Start
selector to the
Start
position (clockwise) and the
engine will fire.
ALL MODELS
7)
Push and hold green power button.
8)
Select the boom function required and operate hand levers in full accordance with
manufacturer’s Operating and Safety manual.
9)
To change control to the basket turn the
Base/Basket
selector to the
Basket
position (anti-
clockwise).
10)
When not in use return machine to stowed position.
Note
: Fully lower the Link booms first
(Lever 4) followed by the Upper boom (Lever 5) for smooth operation. Fully raise and stow all
outriggers, turn the
Base/Basket
selector to the centre “
OFF
” position, remove key and chock
wheels.
EMERGENCY PROCEDURES
11)
Push in red emergency stop to shut down all functions.
12)
Use emergency hand pump (located under control canopy) to provide motive power and
manoeuvre the machine as normal using the hand levers (Basket or Base).
Summary of Contents for SD64 4x4x4
Page 2: ......
Page 21: ...SD64 Series Operating Safety Instructions USA 04 16 Issue 04 19...
Page 48: ......
