3
www.nightwatchersecurity.co.uk
Please contact 0845 900 6764 for further assistance.
INSTALLATION AND WIRING INSTRUCTIONS
Remove the inset back mounting box from the luminaire. Fit the inset back mounting box onto the wall and tighten the screws
at a height that ensures adequate coverage of the area by the infrared detector. The minimum installation height is 2 meters.
And the maximum height is 3 meters.
*Please make sure the voltage and polarity are correct before connection. Incorrect voltage may cause an
electric shock. If you are not sure, please contact your retailer or a qualified electrician.
NOTE: DO NOT REMOVE THE SECURING TAPE ON THE FITTING UNTIL THE UNIT IS
FULLY INSTALLED.
WIRING INSTRUCTIONS
Feed the cable carefully through the back mounting box and bush to avoid abrasion to the cable.
Connect the earth wire to the connector opposite the green/yellow cable.
Connect the brown phase conductor active to the connector opposite the brown cable and tighten the screws.
Connect the blue neutral conductor to the connector opposite the blue cable and tighten the screws.
Check that all connections are correct and tight, as any misconnections will damage the detector.
Re-fit the fitting to the back mounting box.
