7
www.nightwatchersecurity.co.uk
Please contact 0845 900 6764 for further assistance.
Installation
1
Mounting and wiring the light
fixture
2
Mounting and wiring the light
fixture (Continued)
DANGER:
Incorrect voltage may cause electric shock. If you are
not sure, please contact your retailer.
CAUTION:
Do not remove the tape until you finish the installation.
If the tape comes off the light, please replace it or hold
the light head to avoid swiveling and damage to the
product.
CAUTION:
LED lamps are extremely bright. Under no
circumstances should you stare into an LED beam
since this may cause irreparable damage to the eye.
IMPORTANT:
Please make sure the voltage and polarity are correct
before connection.
NOTE:
To ensure correct operation of the sensor, mount the
light fixture so that the traffic passes across the
detector.
Installing your Nightwatcher NW720 on a
wall or building surface
□ Place plastic masonry plugs (CC) into desired
surface aligning holes as shown below.
□ Feed the cable through the back mounting box,
using caution to avoid abrasion to the cable.
□ Wire the unit (A) as follows: (Ensure all wires are
connected securely and that no loose strands are
exposed)
□ Make sure the polarity is correct. Double check the
connections after wiring. Errors may damage the
motion sensor or cause a fire hazard.
□ Using a screwdriver, fasten the unit (A) directly to
surface using drywall screws (BB).
CAUTION:
Please allow 1 minute warm-up time after switching
on.
Do not touch NW720 during warm-up time to avoid
interruption of start-up sequence. Push the RESET
button after switching on.
IMPORTANT:
Remove plastic lens cover from camera and the tape
after installation.
CC
BB
