-6-
[Functions of Component Parts]
(1) 0-Call switch
Pressing the 0-Call switch resets the indication to zero.
The 0-Call switch changes the indication the moment it is released.
Operate the switch by pressing it rather leisurely for a second or so.
(2) 1/2-Call switch-cum-signal output switch
The switch functions as the 1/2-Call switch and also as the signal output switch. The function
selector switch is provided to choose the function in which the switch is to work.
As 1/2-Call switch:
Pressing the 1/2-Call switch halves the indication value as at the time when the switch is
pressed.
The 1/2-Call switch changes the indication value the moment it is released.
Operate the switch by pressing it rather leisurely for a second or so.
As signal output switch:
This switch is intended to instruct the output of signals on the side of this device.
Pressing the signal output switch causes the measured value to be output in RS-232C-
conformant signals through the signal output jack.
The signal output takes place the moment the switch is released.
Operate the switch by pressing it rather leisurely for a second or so.
If the cable is not connected properly or some abnormal condition occurs during
communication, an error (E1, E2) will be displayed for approximately three seconds.
For details, see Section [External Signal Output].
(3) Auxiliary bubble tube
This is designed to check for inclinations in the roll direction (direction perpendicular to the
measurement axis).
