Mark lap completion and start next lap measurement
Press the START/LAP button.
The completed lap number appears above the primary display.
The split time appears for 7 seconds, then the display returns
to the overall time. Completed lap time appears for 7 seconds,
then the display shows the elapsed time for the next lap.
Stop measuring a lap
Press the STOP/NEXT button.
The counting stops, and the word “STOP” appears on the display.
The lap time and total elapsed time appear.
Restart a lap measurement
Press the START/LAP button.
The counting continues.
Note: If you want to save the times for your most recent run,
cycle to the next run. If you want to erase the times for your
most recent run, reset the run.
Cycle to the next run
The chronograph must be stopped to cycle to the next run.
Press and hold the STOP/NEXT button for two seconds.
“HOLD NEXT” flashes in the display. Then the next run sequence
appears at the top of the display. The time digits return to zero.
Your Triax watch will record the next lap times as part of a new run.
7
Start measuring a lap
Press the START/LAP button.
The lap/split time display begins with 1/100 seconds, then
seconds, then minutes. If the accumulated times in a run
proceed to hours, the elapsed hours appear above the
primary display and replace 1/100 seconds in the
secondary display.
M O D E
S TO P / N E X T
S TA R T / L A P
A D J U S T / R E S E T
E L E C T R O L I T E
R U N N U M B E R
S P L I T
S TO P M A R K
a
CHRONOGRAPH
6
In CHRONOGRAPH mode you can
measure and record lap times and
split times for multiple runs.
Recorded times are accessed
in DATA mode.
Lap and split times are displayed
simultaneously. The primary display
is centrally located and larger than
the secondary display, which
appears below. You can select
whether lap or split time occupies
the primary position.
Run - A run is an exercise session consisting of any number of consecutive lap time measurements.
Lap - Lap time is the time required to cover a given segment of a run.
Split - Split time is the total elapsed time in a run up to the completion of a lap.
EN Manual FINAL (RunII) NEW 4/26/99 5:00 PM Page 6
