21
20
1
Turn the power switch on, open the
camera back by sliding the camera back
lock release lever and load film.
• Film cartridge can be loaded smoothly if inserted
from the bottom.
2
Pull film leader across to red index mark.
• Make sure to align the film leader to the red index
mark; if the film leader is not properly aligned to the
index mark (short of or beyond the mark), film may
not be loaded properly.
• Hold the film cartridge and ensure film is properly
positioned with no slack.
3
Gently close the camera back until the
camera back snaps closed. Film
automatically advances to the first frame.
• When
1
appears on the LCD panel, the film has
advanced to the first frame.
• When
E
appears in the LCD panel or
Err
and
E
in
the LCD panel and
Err
in viewfinder blink, film is
not properly installed. Open the camera back again
and reload film by aligning the film leader to the red
index mark.
• Frame number display remains when the power
switch is off.
NOTE: Loading/removing film
Shutter curtains are very thin. Do not touch the shutter
curtains with your finger or the film leader.
Load Film
3
Turn the power switch on and load DX-coded film. With DX-coded film,
film speed will be set automatically (ISO 25-5000). Closing the camera
back after loading film automatically advances the film to the first frame.
DX-coded film
With DX-coded film, film speed will be set
automatically between ISO 25 to ISO 5000.
Film speed is set to ISO 100 with non-DX-
coded film.
Check points
• Avoid direct sunlight when changing film outdoors.
• You can check the number of available exposures on the film roll and film
speed through the film confirmation window.
• Infrared films cannot be used with this camera since an infrared sensor is used
for the detection of the film frame position.
DX-coded film
ISO
(film speed)
DX mark
PREP
ARA
TION
F65 (E) 02.12.27 5:43 PM Page 20