15
Inserting the Battery
First Ste
p
s
Removing the Battery
Turn the camera off and make sure that the power-on
lamp and the monitor have gone out before opening
the battery-chamber/memory card slot cover.
To eject the battery, turn the orange battery latch in
the direction shown
1
. The battery can then be
removed by hand
2
.
•
Note that the battery may become hot during use;
observe due caution when removing the battery.
Turning On and Off the Camera
To turn on the camera, press the power switch. The
power-on lamp (green) will light for a moment and the
monitor will turn on.
To turn off the camera, press the power switch again.
When the camera turns off, both the power-on lamp
and monitor will turn off.
If the camera is turned off, hold down
c
to turn the camera on in playback mode.
D
Auto Power-Off (Standby Mode)
•
The monitor will dim to reduce the drain on the battery if no operations are performed for about
five seconds. The monitor will brighten when camera controls are used. If no operations are
performed for about a minute (default setting), the monitor will turn off automatically and the
camera will enter standby mode. The camera will turn off automatically if no operations are
performed for three minutes (Auto off) (
A
125). To turn on the monitor of the standby mode,
press the power button or shutter-release button.
•
The standby mode time setting can be changed using
Auto off
on the setup menu. (
A
125)
