208
n
❚❚
Manual Cleaning
If foreign matter can not be removed from the low-pass filter using the
Clean image
sensor
option in the setup menu (
0
206), the filter can be cleaned manually as
described below. Note, however, that the filter is extremely delicate and easily
damaged. Nikon recommends that the filter be cleaned only by Nikon-authorized
service personnel.
1
Charge the battery or connect an AC adapter.
A reliable power source is required when inspecting or cleaning the low-pass
filter. Turn the camera off and insert a fully-charged EN-EL9a battery or connect
an optional EP-5 power connector and EH-5a AC adapter.
2
Remove the lens.
Turn the camera off and remove the lens.
3
Select
Lock mirror up for cleaning
.
Turn the camera on and press the
G
button to display the menus. Highlight
Lock
mirror up for cleaning
in the setup menu
and press
2
(note that this option is not
available at battery levels of
H
or below).
4
Press
J
.
The message shown at right will be displayed in the
monitor. To restore normal operation without inspecting
the low-pass filter, turn the camera off.
5
Raise the mirror.
Press the shutter-release button all the way down. The
mirror will be raised and the shutter curtain will open,
revealing the low-pass filter.
6
Examine the low-pass filter.
Holding the camera so that light falls on the low-pass filter,
examine the filter for dust or lint. If no foreign objects are
present, proceed to Step 8.
G
button
Summary of Contents for D5000
