96
r
3
Select a preset.
Press the
L
(
U
) button and rotate the sub-command dial until the desired
white balance preset (d-1 to d-6) is displayed in the control panel.
4
Select direct measurement mode.
Release the
L
(
U
) button briefly and then press the
button until the
L
icon in the control panel starts to
flash. A flashing
D
will also appear in the viewfinder.
The displays will flash for about six seconds.
5
Measure white balance.
Before the indicators stop flashing, frame the reference
object so that it fills the viewfinder and press the
shutter-release button all the way down. The camera
will measure a value for white balance and store it in the preset selected in Step
3. No photograph will be recorded; white balance can be measured accurately
even when the camera is not in focus.
L
(
U
) button
Sub-command dial
Control panel
A
Protected Presets
If the current preset is protected (
3
will flash in the control panel and viewfinder
if you attempt to measure a new value.
Control panel
Viewfinder
Summary of Contents for D7100
