258
U
If
Yes
is selected, adjustments that are normally made by rotating the command dial
while holding a button can instead be made by rotating the command dial after the
button is released (setting ends when the button is pressed again, the shutter-release
button is pressed halfway, or the standby timer expires). The following buttons are
affected: the
E
,
M
(
Y
),
W
(
S
),
X
(
T
),
L
(
U
), AF-mode,
Z
(
Q
), or
D
,
Fn
,
preview, and
A
AE-L
/
AF-L
buttons. The
Fn
and preview buttons are only affected when
assigned
Choose image area
,
Choose non-CPU lens number
,
Active D-Lighting
,
or
HDR (high dynamic range)
using Custom Setting f2 (
Assign Fn button
) or f3
(
Assign preview button
). The
A
AE-L
/
AF-L
button is only affected when assigned
Choose image area
or
Choose non-CPU lens number
using Custom Setting f4
(
Assign AE-L/AF-L button
). Note that the standby timer will not expire when
No
limit
is selected for Custom Setting c2 (
Standby timer
).
Selecting
Enable release
allows the shutter to be released when no memory card is
inserted, although no pictures will be recorded (they will however be displayed in the
monitor in demo mode). If
Release locked
is selected, the shutter-release button is
only enabled when a memory card is inserted in the camera.
If
(
W
) is selected, the exposure indicators in the control panel,
viewfinder, and information display are displayed with negative values on the left
and positive values on the right. Select
(
V
) to display positive
values on the left and negative values on the right.
f6: Release Button to Use Dial
G
button
➜
A
Custom Settings menu
f7: Slot Empty Release Lock
G
button
➜
A
Custom Settings menu
f8: Reverse Indicators
G
button
➜
A
Custom Settings menu
Summary of Contents for D7100
