315
n
❚❚
Manual Cleaning
If foreign matter can not be removed from the image sensor using the
Clean image
sensor
option in the setup menu (
313), the sensor can be cleaned manually as
described below. Note, however, that the sensor is extremely delicate and easily
damaged. Nikon recommends that the sensor be cleaned only by Nikon-authorized
service personnel.
1
Charge the battery or connect an AC adapter.
A reliable power source is required when inspecting or cleaning the image
sensor. Turn the camera off and insert a fully-charged EN-EL15 battery or
connect an optional EP-5B power connector and EH-5b AC adapter. The
Lock
mirror up for cleaning
option is only available in the setup menu at battery
levels over
J
.
2
Remove the lens.
Turn the camera off and remove the lens.
3
Select
Lock mirror up for cleaning
.
Turn the camera on and press the
G
button to display the menus. Highlight
Lock
mirror up for cleaning
in the setup menu
and press
2
.
4
Press
J
.
The message shown at right will be
displayed in the monitor and a row of dashes
will appear in the control panel and
viewfinder. To restore normal operation
without inspecting the image sensor, turn
the camera off.
G
button
Summary of Contents for D7100
